Game Input MultipleXer

I think I just found what was wrong. Apparently the /boot/cmdline.txt file was corrupted (even after a fresh raspbian install?!). So the UART wasn't working properly. :oops: I used this guide to restore the file and disable the console login. When I run gimx now I get this: gimx -p /dev/ttyAMA0 -c L...

Here are the measurements:

Pi | Teensy | Voltage
+----+--------+--------
| 10 | D3 | ~2V
| 10 | GND | ~3V

Affirm. I first power up the RPI. Than the PS4 and then try to start gimx.

Still not working. I tried reinstalling without any success. Here is the log file: global option -l with value `log.txt' controller #1: option -p with value `/dev/ttyAMA0' now reading arguments for controller #2 global option -c with value `LogitechDrivingForcePro_G29.xml' status flag is set GIMX 5....

Still no luck :? pi@raspberrypi:~ $ gimx -p /dev/ttyACM0 -c LogitechDrivingForcePro_G29.xml --status controller #1: option -p with value `/dev/ttyACM0' now reading arguments for controller #2 global option -c with value `LogitechDrivingForcePro_G29.xml' status flag is set native mode command sent to...

Hi all, I followed this great tutorial on for a RPI build. However I cant seem to get it to work. When I try to active gimx with gimx -p /dev/ttyUSB0 -c LogitechDrivingForcePro_G29.xml --status (I use this instead of the autostart for troubleshooting) The output is as followed: controller #1: option...

Thx. I will see what I can do, however it may take a while.

Hi,

First of all i'd like to say: great software! It is absolutely brilliant with Project Cars on my PS4 and my Driving Force Pro!

Here is the configuration I used:
https://www.dropbox.com/s/v71sv1vkx6jur ... 9.xml?dl=0

Cheers