Search found 333 matches

by GoDlike
Tue May 22, 2018 4:44 pm
Forum: Support
Topic: FFB only centering spring
Replies: 18
Views: 419

Re: FFB only centering spring

You can always use a service like pastebin and give us a link here
by GoDlike
Mon May 21, 2018 7:12 pm
Forum: Support
Topic: RPi3 without any adapter
Replies: 4
Views: 43

Re: RPi3 without any adapter

Arduino due is an ARM chip. For the firmware to work you need atmega32u4 based chip.
by GoDlike
Mon May 21, 2018 6:10 pm
Forum: Support
Topic: Titanfall 2 Mouse Input
Replies: 3
Views: 39

Re: Titanfall 2 Mouse Input

That's because you are using config for another game. You need to make a new using Mouse calibration.
by GoDlike
Mon May 21, 2018 1:01 pm
Forum: Support
Topic: Titanfall 2 Mouse Input
Replies: 3
Views: 39

Re: Titanfall 2 Mouse Input

Hello, I am not sure if I understand your post correctly. You have a problem with faster mouse moves in this game while input is correct with slow movement? If yes you should play with acceleration value. In mouse calibration mode as far as I remember you need to push ctrl + f1 combo. There's line o...
by GoDlike
Mon May 21, 2018 7:25 am
Forum: General Discussion
Topic: Xbox controller without 3.5 mm jack
Replies: 1
Views: 35

Re: Xbox controller without 3.5 mm jack

You mean the one with Jack? Currently no but we're working on it. No ETA though.
by GoDlike
Sun May 13, 2018 9:22 am
Forum: GIMX Discussion
Topic: [Tutorial] Logitech G27 (and other wheels) on PS4 using Pi
Replies: 46
Views: 26650

Re: [Tutorial] Logitech G27 (and other wheels) on PS4 using Pi

Make sure you have EMUG29PS4 firmware if you want to use wheel and you bind your wheel to the config.
by GoDlike
Sun May 13, 2018 7:47 am
Forum: Tutorials
Topic: Use Wii Nunchuck as Motion-Controller
Replies: 1
Views: 64

Re: Use Wii Nunchuck as Motion-Controller

Hello,

Thanks for the tutorial! We're always happy when someone uses gimx successfully and we love when you find a new ways to play!

This post contains a lot of useful info so I will move it to the Tutorials section if you don't mind :)

Regards,
Daniel
by GoDlike
Sun May 13, 2018 7:45 am
Forum: GIMX Discussion
Topic: Error when installing
Replies: 1
Views: 46

Re: Error when installing

What's your system?
by GoDlike
Fri May 11, 2018 4:29 pm
Forum: Support
Topic: Can't get it working
Replies: 6
Views: 136

Re: Can't get it working

Every config is different. I think I used 3600 for FC5. It's listed if you open config with editor like gimx-fpsconfig. If it's still too low you can always increase sensitivity.
by GoDlike
Fri May 11, 2018 2:52 pm
Forum: Support
Topic: Can't get it working
Replies: 6
Views: 136

Re: Can't get it working

You currently have EMUG29_PS4 firmware loaded and it's intended to use with steering wheel. What you need is to flash EMUPS4 firmware that allows to use keyboard and mouse. Just run gimx-loader and follow the instructions. After flashing you can play FC5 without problems ;-)