Game Input MultipleXer

Hi Matlo,

Tried it and yes it's not always stable... But I found that you have about 3-5 sec. before the mouse is locked in as the controller.

In this small time window you can press the minimize button on the cmd window.

It's a great help when streaming your Xbox to your PC

-Tar

Hi,

I'm here to use the gimx for the Xbox one and will try helping out if I can now that I got mine working:)

/Tar

Hi

One question.

Is it possible to run the gimx with the command prompt window disabled or minimized?

/Tar

Hi Matlo I used the new configfile. needed to put the same mapping on both profiles and did this startup 0> Make sure XBOX One controller is connected pc and is shut off. 1> Disconnect AVR USB board and USB to UART adapter!! Yes, both USB and Mini USB. 2> Plug the AVR USB board (e.g. Teensy, Arduino...

I do that later today and post it here, I also found that the configuration file "XOnePadUsbXinput.xml" is a little more generic than I thought. So I tried setting up a file on at different computer and the "joystick not found: X360 Controller (0)" is replaced with an ok message ...

Hi, I can add that I have the old controller. and I used the 64bit version of the program and driver. Might be important. At the time where the program asks for a setup file I choose the one of the Xbox-one controller but if I go into the fps config there is no set up I have to set it up manual. On ...

Hi I just got the emulator from the shop. uploaded the xone firmware. OK Installed the software and driver. OK installed the driver to the controller. OK followed the instruction on the homepage multiple time. NOT OK got the "joystick not found: X360 Controller (0)" Followed the suggesten ...