Matlo, botters,
At older versions of GIMX (4.x) macro did stop after some iterations of "looping".
Haven't used macros for a long time.
Do you know if this has been corrected so if we run macro in "loop" it will be infinitive?
I'd like to run short macro and repeat it for hours instead of writing long script and copy/paste it every time I change it.
Macro loop question
Re: Macro loop question
Hi,
It should not stop unexpectedly, and I don't remember any such problem.
It should not stop unexpectedly, and I don't remember any such problem.
GIMX creator
-
- Posts: 69
- Joined: Sat Feb 23, 2013 4:11 pm
Re: Macro loop question
There was always the problem.
I just don't think anyone else is botting with GIMX
I have tested it yesterday.
I can't tell you how many times, but macro triggers for some amount of times and then it stops.
When I get some free time I'll run GIMX with log to test it.
As a workaround I write simple script and copy/paste it multiple times
I just don't think anyone else is botting with GIMX
I have tested it yesterday.
I can't tell you how many times, but macro triggers for some amount of times and then it stops.
When I get some free time I'll run GIMX with log to test it.
As a workaround I write simple script and copy/paste it multiple times
Re: Macro loop question
Last time I used macros was for testing the TIAO GBoard: https://blog.gimx.fr/tiao-gboard/
It worked for more than 10 hours without any issue.
It worked for more than 10 hours without any issue.
GIMX creator