ERROR: FAILED TO READ PACKET HEADER FROM THE GIMX ADAPTER

Discuss everything to do with GIMX here
Post Reply
Pr2
Posts: 12
Joined: Fri Jan 26, 2018 12:46 am

ERROR: FAILED TO READ PACKET HEADER FROM THE GIMX ADAPTER

Post by Pr2 » Sun Apr 01, 2018 8:43 pm

HI

Im trying to setup a DYI adapter using raspberry pi and arduino pro micro.

I have intalled GIMX 7.2 to do so

The problem is that when I try to start GIMX, I allways get the following error:
ERROR: FAILED TO READ PACKET HEADER FROM THE GIMX ADAPTER

I have flashed my AVR board again, checked the wiring and tryed to change TX and RX to see if are mislabelled. Previously I was getting an similar error on async.c but I disabled hciuart and i got rid of it, Im not sure if this is correct.

Any ideas¿? I am performing my tests pluging only AVR board, not connecting G27 neither DS4 but I think the error have nothing to do with those components, right?¿

Thx!

EDIT: I tested my RPI UART using "minicon -D /dev/ttyserial0" and bypassing 8 and 10 pins, so UART looks working fine. Also my PRO micro looks fine as long as it can load correctly firmwares using avrdude.

User avatar
GoDlike
Posts: 566
Joined: Thu Apr 28, 2016 12:47 pm
Location: Poland

Re: ERROR: FAILED TO READ PACKET HEADER FROM THE GIMX ADAPTER

Post by GoDlike » Sun Apr 01, 2018 9:18 pm

As far as I remember pro micro is on atmega32u4. Please try flashing firmware with gimx-loader.
My hardware: PS3 Slim CFW 4.80 | PS4 Pro 500 Million LE | Xbox One S
Steam: Godlike_RU | PSN: GoDlike_RU | XBL: GoDlike

User avatar
Matlo
Posts: 5047
Joined: Wed Jul 06, 2011 7:01 am
Location: France
Contact:

Re: ERROR: FAILED TO READ PACKET HEADER FROM THE GIMX ADAPTER

Post by Matlo » Tue Apr 03, 2018 8:23 pm

Please post in the support section and provide the details requested here:
viewtopic.php?f=5&t=691
GIMX creator Donate Shop

Post Reply