How to check if firmware was uploaded correctly?

Need help? Ask here and someone will help
Post Reply
mlota
Posts: 2
Joined: Wed Aug 16, 2017 2:00 pm

How to check if firmware was uploaded correctly?

Post by mlota » Wed Aug 16, 2017 2:55 pm

Hi all,

I'm using Arduino Leonardo, serial CP2102, and uploadded the EMUXONE.hex (gimx-launcher 6.8 x86) by 'Help -> Update Firmware -> Load'.
The upload was successful (plugging both usb, pressing reset, ...).

How can I check if firmware was uploaded correctly?

If I plug the arduino usb directly on the PC should something come up? (in Device Manager)
...like 'Controller'...

Image

User avatar
Matlo
Posts: 4451
Joined: Wed Jul 06, 2011 7:01 am
Location: France
Contact:

Re: How to check if firmware was uploaded correctly?

Post by Matlo » Thu Aug 17, 2017 8:42 am

The info box says that the firmware was loaded successfully, why not trusting it? ;)

The firmware waits for the start order from the GIMX software, which is why you don't see any device in the device manager.
GIMX creator Donate Shop

Post Reply