DS4 connects to PC by USB only when it is not fully charged?
Posted: Thu Oct 19, 2017 9:37 pm
Hello guys,
Today I've received Arduino Leonardo and FTDI232r and I have connected everything to the ubuntu 16.04 .
For a while all the things were visible in the system (checked by lsusb command) including the connected by usb cable DS4 controller.
Not everything was working well, because I have been using unmapped configuration, but anyway when i realised that it was too late and my DS4 is not visible for the system. I think that the problem is that controller doesn't connect to the usb port of PC, because it is fully charged. Is it possible?
It is worth mentioning that after few minutes, when I was using my controller (so battery slightly discharged), the controller was again visible for less than minute (Until it fully charged again?). Anyone has the same problem?
Today I've received Arduino Leonardo and FTDI232r and I have connected everything to the ubuntu 16.04 .
For a while all the things were visible in the system (checked by lsusb command) including the connected by usb cable DS4 controller.
Not everything was working well, because I have been using unmapped configuration, but anyway when i realised that it was too late and my DS4 is not visible for the system. I think that the problem is that controller doesn't connect to the usb port of PC, because it is fully charged. Is it possible?
It is worth mentioning that after few minutes, when I was using my controller (so battery slightly discharged), the controller was again visible for less than minute (Until it fully charged again?). Anyone has the same problem?