Page 3 of 3
Re: GIMX doesn't detect adapter
Posted: Fri Dec 01, 2017 4:34 am
by gcardy
I mentioned that I did check the continuity from pin to pin with a multimeter and the cables plugged in. That is what you are suggesting, right?
Re: GIMX doesn't detect adapter
Posted: Fri Dec 01, 2017 6:18 am
by GoDlike
I don't see any other possibility than faulty AVR Board then
Re: GIMX doesn't detect adapter
Posted: Thu Jan 11, 2018 1:33 am
by gcardy
I received my third UART board today after waiting the past 5 weeks for it to arrive. Same error.
Jumped on the PJRC forums to ask for tech help since you mentioned that it was a bad teensy. I found this thread:
https://forum.pjrc.com/threads/35071-Te ... light=gimx
It says that if the blinking LED example works, the board is good. Maybe this is a Windows issue, or something with my MB.
Re: GIMX doesn't detect adapter
Posted: Thu Jan 11, 2018 10:30 am
by GoDlike
Teensy may be a chinese clone, it does not have to be bad. If I were you would test it on another PC .
You may buy official adapter, it's tested and 100% working. If you prefer DIY then try with something generic on atmega32U4 like Leonardo clone.
Re: GIMX doesn't detect adapter
Posted: Fri Jan 12, 2018 3:03 am
by gcardy
I finally broke down and installed Windows 10 via bootcamp. I'm still seeing the same exact error, and the only thing not different is the teensy. I guess ill head over to the PJRC forums and see if someone can help me figure this thing out.
Re: GIMX doesn't detect adapter
Posted: Wed Jan 17, 2018 6:57 am
by simonzeecksvard
Have you got it to work?
I just have the same problem and can not make it work.