DIY USB Pro Micro flashing

Need help? Ask here and someone will help
Post Reply
avdyushin
Posts: 2
Joined: Mon Jan 27, 2020 8:42 am
Location: Rotterdam
Contact:

DIY USB Pro Micro flashing

Post by avdyushin » Mon Jan 27, 2020 9:07 am

Hello,

I've Pro Micro atmega32u4 5v/16MHz with connected CP2102.

When Pro Micro has empty sketch uploaded with Arduino app and all connected to my Mac I see this two devices connected to USB:
  • CP2102 USB to UART Bridge Controller
  • Arduino Leonardo
As expected.

After successful flashing EMUPS3 firmware using avrdude and reconnecting Pro Micro it's not detected as any USB device (excluding bootloader mode).
But I was expecting to see something like Sony Dualshock 3 controller in USB devices list on Mac, isn't it?

I know GIMX not supported my Mac, but I'm trying to setup USB adapter first.

User avatar
Matlo
Posts: 5554
Joined: Wed Jul 06, 2011 7:01 am
Location: France
Contact:

Re: DIY USB Pro Micro flashing

Post by Matlo » Wed Jan 29, 2020 10:13 am

Hello,

This is expected, the controller should be detected after click start in gimx-launcher.
GIMX creator Donate Shop

avdyushin
Posts: 2
Joined: Mon Jan 27, 2020 8:42 am
Location: Rotterdam
Contact:

Re: DIY USB Pro Micro flashing

Post by avdyushin » Wed Jan 29, 2020 2:25 pm

Thanks, good to know

Post Reply