No controller and adapter connected

Need help? Ask here and someone will help
Post Reply
gravitythedfyr
Posts: 5
Joined: Sat Jun 27, 2020 7:01 pm

No controller and adapter connected

Post by gravitythedfyr »

I have gimx on my RPI 3 and have everything set up how it should be (adapter plugged in with teensy going into the pi, and a controller plugged in). I know the cable works because I use it daily for a pro wired controller (not the one I plugged into the pi). I have tried switching RX and TX to no avail, any help?

User avatar
LoneWolf81
Posts: 145
Joined: Sat Jun 15, 2019 11:49 am
Location: South Africa

Re: No controller and adapter connected

Post by LoneWolf81 »

Hi

Please add a log file also what firmware did you load onto the teensy is the teensy a clone or genuine ?

Post clear pictures of the adapter and what uart adapter are you using ?
Please Remember to Post your Log file in the support section , that way its easier and faster to start identifying the issue thus helping you to sort it out so you can enjoy GIMX :D .

User avatar
Matlo
Posts: 5680
Joined: Wed Jul 06, 2011 7:01 am
Location: France
Contact:

Re: No controller and adapter connected

Post by Matlo »

Teensy/atmega32u4 side should be connected to the target (gaming console).

For further help please provide the details requested by LoneWolf81.
GIMX creator Donate Shop

Post Reply