Hello, I am new here. I have a small issue. When I edit the settings using the config program and calibration gui during the game, it works for a couple of minutes, but later movement locks up and eventually disconnects (controller). Are there limitations when editing dz, x-y ratios, multipliers, etc. that could cause crashing? I am currently using:
-Linux: Ubuntu v11.04
-BT Dongle:Rocket Fish RF-MRBTAD
-Mouse: Logitech MX1100 (Wireless and 1600 max dpi)
Thanks in advance. :]
Locking up issues when configuring
Locking up issues when configuring
Last edited by Theo on Fri Dec 02, 2011 8:43 am, edited 1 time in total.
Re: Locking up issues when configuring
Does it also disconnect without the calibration gui?
GIMX creator
Re: Locking up issues when configuring
Yes. Tested it without GUI and it works fine for a minute or so then locks up and disconnects.
*update* Now it doesn't recognized controller. Strange.
*update* Now it doesn't recognized controller. Strange.
Re: Locking up issues when configuring
This is an issue people get with broadcom dongle. Sadly there's no fix for that. I suggest you to get a CSR bluecore4 dongle.
GIMX creator
Re: Locking up issues when configuring
Working again
*update*
Switched to CSR Bluecore4-Rom dongle and it works perfectly. Sorry for any troubles! Seems that Broadcom15 dongles are a no no...
*update*
Switched to CSR Bluecore4-Rom dongle and it works perfectly. Sorry for any troubles! Seems that Broadcom15 dongles are a no no...