PS4 GTGF Pro Wheel Stops working Windows 8.1 Enterprise

[Flateric]

Hi,

Wonder if anybody can point me in the right direction. I have built my adapter with a Teensy board, connected everything up and to my surprise everything worked fine and I started playing Drive Club on my Driving Force GT. Unfortunately after about two minutes the steering wheel became unresponsive to all input and I had to shut everything down. Started everything up again and the exact same thing happened. When I check my computer at the point it becomes unresponsive the log looks like this.

https://postimg.org/image/jq611x9oh/10f9dbf6/

I've made sure all my USB devices are set so Windows won't power them down. I have everything plugged directly into my computer (no hub) and I've tried different USB cables but each time get the same result.

I've searched and seen one other instance of unhandled packet but it didn't seem relevent.

Any help would be greatly appreciated.

[tiagovt]

show final log

[Matlo]

Hi,
Please post a log file and a clear picture showing the wiring.
https://gimx.fr/forum/viewtopic.php?f=5&t=691

[Flateric]

Hi,

Apologies, I didn't post the pics because I thought it must be right if it works at the begining but here they are.

http://postimg.org/gallery/f5w8gzhe/

I'll grab the log file shortly.

[Flateric]

As far as I can tell the log doesn't show anything out of the ordinary. It just seems to be logging inputs until I have to close GIMX and turn off the PS4 due to it failing to respond to the wheel.

http://pastebin.com/x3T3iMuH

[Matlo]

Are the pins soldered on the top side of the Teensy? It can't work without soldered pins or wires.

[Flateric]

No they aren't, I followed the guide here

http://gimx.fr/wiki/index.php?title=DIY ... or_dummies

titled "No Soldering Required" so didn't think it was needed. I don't have a soldering iron so think I'll have to abandon the project. Thankyou for getting back to me though.

Regards,
Paul

[Matlo]

Soldering is not required when using a Teensy 2.0 with header pins.
http://pjrc.com/store/teensy_pins.html

[Flateric]

OK, never suspected there'd be an issue with the hardware with it working for a short while everytime and then stopping. Assumed it would be some kind of software issue not transferring the data through to the PS4. Cheers for the reply.

Regards,
Paul

[Flateric]

OK, decided I'd come this far so might as well carry on. I've soldered the pins but get the same issue. Has anybody got any further advice?