I have been trying to make a DIY USB adapter using a Teesy 2.0 and a serial adapter.
I managed to load the firmware firmwares-5.8\EMU360\atmega32u4.hex on it but for some reason when I plug it all together and click Start from the Gimx Launcher, it show multiple popups saying "Cannot open file for writing".
The USB cables and the serial adapter are good, I used them for other Arduino projects.
I double checked that RX was connected to TX in both sides, I even tried invert them, still the same error.
I tried on an Xbox 360 and a Windows 10 PC.
When I plug the Teensy to my PC, I don't hear the sound it should make when a USB device is plugged. Though, I do when I press the Program Mode button.
Here's a log file
Code: Select all
global option -l with value `log.txt'
global option -c with value `test.xml'
controller #1: option -p with value `COM3'
now reading arguments for controller #2
status flag is set
subpos flag is set
force_updates flag is set
GIMX 6.3 x86_64
Windows 10 (or later) x64
Kernel version: 10.0 (14393)
windows/async.c:344 async_read_timeout: ReadFile failed: timeout expired.
can't read packet header
gimx.c:208 SDL_main: no adapter detected
Here is a screen shot, on the serial adapter, RX is the green cable and TX is the blue cable. Black is ground
Thank you for you help