Game Input MultipleXer

looks good. the bootloader is compiling and only takes 2k in memory. I just have to put it on the board and see if it works

crossing my fingers.

cTiger on the verge of bricking an arduino UNO

removing leds, hardcoding the Bdaddress({0x00, 0x11, 0x67, 0xD4, 0x16, 0x5F}) and using -ffunction-sections -fdata-sections -Wl,--gc-sections -mcall-prologues as extra flags might help you to go below 4k.

could you try ?

thanks

cT

the chip is a ATmega8U2 but all tutorials say to use AT90USB82 (datasheet are similar)

it's an arduino UNO (http://arduino.cc/en/Main/ArduinoBoardUno)

I don't know the bootloader size. for now the chip still has the default HEX


btw how did you skrink the program size ?
(i guess you used PROGMEM for the arrays?)

cTiger

when I set the chip type in FLIP, I can see FlashBuffer information 4KB.

could that be of any relevance ?

still the same error .

strange, I ve double checked the datasheet and the chip has 8-Kbyte self-programming Flash Program Memory, 512-byte SRAM, 512-byte EEPROM. so it should load. I tried a HEX for arduino and it loads so it is a problem with the built HEX. any other bright ideas?

ctiger

I arrived to the same result and I was looking to see if I could remove useless stuff but no success yet. would you have any great hints ?

thanks but I also get the same error "Address is out of range"

any clues why ?

After struggling quite a bit to get the code to compile, I finally succeeded or I thought so. When i load the HEX file in FLIP, I get Address Out of Range. I guess I must has screwed up some settings in Eclipse, here is a partial output of the compilation. Are there any special settings to configure...

Hi, I'm trying to register a bluetooth dongle (which cannot have its address changed) with my PS3. I have aN Arduino Uno with a at90usb82 chip but I can only find on the site sixaxis_pair_emu.hex (diyps3controller v2 - Sixpair-emu - firmware for the Teensy++) for at90usb1286. would it be possible to...