Search found 551 matches

by kaiba_seto2004
Sat Nov 17, 2018 7:06 am
Forum: Configurations and Requests
Topic: [Config][XB1]PUBG 1:1
Replies: 5
Views: 9538

Re: [Config][XB1]PUBG 1:1

IF game updates its aiming system, you can't sure untill try it yourself.
by kaiba_seto2004
Sat Nov 17, 2018 2:09 am
Forum: General Discussion
Topic: Where do I put the config file
Replies: 1
Views: 3237

Re: Where do I put the config file

You can open Gimx Launcher and press File / Open config directory. Gimx will bring you to right place.
by kaiba_seto2004
Fri Nov 09, 2018 7:13 pm
Forum: Support
Topic: PS4 not detecting controller / GIMX not sending signal
Replies: 5
Views: 6020

Re: PS4 not detecting controller / GIMX not sending signal

I notice something:
- You didn't turn off your Dualshock 4 before start GIMX.
- You installed GIMX x86 on 64bit Windows.
- Remove check mark on Multiple Mice and Keyboards from gimx-config / advanced
by kaiba_seto2004
Tue Nov 06, 2018 2:50 am
Forum: Support
Topic: Anyway to use a rockcandy xbox 360 controller?
Replies: 1
Views: 2136

Re: Anyway to use a rockcandy xbox 360 controller?

The answer is no, official wired controller is the only one.
by kaiba_seto2004
Tue Oct 23, 2018 12:23 pm
Forum: Configurations and Requests
Topic: [Config][PS4]Tom Clancy's The Division
Replies: 3
Views: 4717

[Config][PS4]Tom Clancy's The Division

Hello everyone, Today I tried to mess again with this game, I've also tried with Cybereu's config (on repo) but I think that one is not so good. So I changed values based on his config. Many thanks to Cybereu. https://steamcdn-a.akamaihd.net/steam/apps/365590/header.jpg?t=1537951171 Game: Tom Clancy...
by kaiba_seto2004
Mon Oct 08, 2018 9:26 am
Forum: General Discussion
Topic: Accuforce Pro V2, HPP PRX pedals, and GIMX
Replies: 14
Views: 13928

Re: Accuforce Pro V2, HPP PRX pedals, and GIMX

Did you install Logitech Gaming Software ?
by kaiba_seto2004
Sun Oct 07, 2018 10:27 pm
Forum: Support
Topic: GIMX with Arduino Micro
Replies: 12
Views: 12653

Re: GIMX with Arduino Micro

Well, I don't think you can replace usb uart with arduino.
by kaiba_seto2004
Sun Oct 07, 2018 10:24 pm
Forum: General Discussion
Topic: Accuforce Pro V2, HPP PRX pedals, and GIMX
Replies: 14
Views: 13928

Re: Accuforce Pro V2, HPP PRX pedals, and GIMX

The microusb side is connected to target system (here is pc also), so you need to connect both sides to pc.
Do the same thing when uploading firmware.
by kaiba_seto2004
Sun Oct 07, 2018 10:21 pm
Forum: Support
Topic: HPP PRX Pedals and Accuforce Pro V2
Replies: 1
Views: 3098

Re: HPP PRX Pedals and Accuforce Pro V2

Hello,

Just 1 gimx adapter, that is what you need :)