Game Input MultipleXer

raceguy wrote: ↑Mon Oct 30, 2017 3:56 am I'm having the same issue with the "dial up" and "dial down" emulation. Pressing the mapped button once acts like it's being held down, so there's no way to step the TCS control in GT Sport a single setting at a time. Instead it just jumps from 0 to 5 and back to 0.

naldin wrote: ↑Mon Oct 30, 2017 1:37 pm

raceguy wrote: ↑Mon Oct 30, 2017 3:56 am I'm having the same issue with the "dial up" and "dial down" emulation. Pressing the mapped button once acts like it's being held down, so there's no way to step the TCS control in GT Sport a single setting at a time. Instead it just jumps from 0 to 5 and back to 0.

It is happening here too but only with GT Sport. With Project Cars I can use the dial without problems. For GT Sport I remapped in game the dial to (+/-) and worked.

claucla wrote: ↑Mon Oct 30, 2017 3:53 pm

naldin wrote: ↑Mon Oct 30, 2017 1:37 pm

raceguy wrote: ↑Mon Oct 30, 2017 3:56 am I'm having the same issue with the "dial up" and "dial down" emulation. Pressing the mapped button once acts like it's being held down, so there's no way to step the TCS control in GT Sport a single setting at a time. Instead it just jumps from 0 to 5 and back to 0.

It is happening here too but only with GT Sport. With Project Cars I can use the dial without problems. For GT Sport I remapped in game the dial to (+/-) and worked.

I also tried in game, but I did not succeed. what commands you used?

claucla wrote: ↑Mon Oct 30, 2017 4:45 pm So are the recommended settings. I have changed the right turn signal with rear view and left turn signal with e-brake, the same for the rest.

Matlo wrote: ↑Tue Oct 31, 2017 9:28 pm Just reviewed the GIMX source code.
The only potential issue is that dial up, dial down and enter are conflicting.
For example if you hold + and then press enter this releases + when it should still be pressed.

The problem you are seeing may be a timing issue. With a real dial the button is pressed a really short time (one refresh period, which is 5ms). With a standard button it is pressed much longer.

Something to try is to use a macro to control the timing. For example if you want to use button 21 to control dial up, remove button 21 from config, and bind key 'p' to dial up instead. Then add this in a dial.txt file located in the macro directory:

Code: Select all

MACRO JBUTTONDOWN 21
KEYDOWN p
DELAY 5
KEYUP p

The macro directory is at the same level as the config directory. If it does not exist, just create it (beware, directory name is case sensitive).