GIMX 3.0

Updates and News about GIMX
Post Reply
User avatar
Matlo
Posts: 5768
Joined: Wed Jul 06, 2011 7:01 am
Location: France
Contact:

GIMX 3.0

Post by Matlo »

This release brings PS4 support over USB in both Ubuntu and Windows!

PS4 support over USB works using the DIY USB adapter.
Note: when gimx is running it is required to have a DS4 connected with a micro USB cable, for authentication purposes.
On Windows, the DS4 driver has to be replaced with the libusbK driver.

Please report issues through there: link.

Read GIMX 1.00 annoucement in case of upgrade from GIMX 0.51 or older.
Read GIMX 1.10 annoucement in case of upgrade from GIMX 1.02 or older.

Known issues

Fixed issues.

Software download.
Firmware download.
mat.lau@laposte.net Fundraising for GIMX PS4 / Xbox One support.

Fixed issues
  • #273: [PS4][DIY USB adapter] Support for the PS4 over USB.
GIMX creator
gobbledygook
Posts: 3
Joined: Thu Aug 28, 2014 12:17 am
Location: Japan

Re: GIMX 3.0

Post by gobbledygook »

I tryed to use Arduino-Leonardo(no overwritten bootloader) and PL2303HX-UART module. its work!
but ubuntu only. On windows(win7, 64bit), GIMX application down A few seconds later after PS4 connection.
(error message: libusb_submit_tansfer: Input/Output Error.\n adapter_forward_data_out failed)

I believe this project will become better. Because this project is very cool. ;)

Thanks for reading to the end my poor english.
User avatar
Matlo
Posts: 5768
Joined: Wed Jul 06, 2011 7:01 am
Location: France
Contact:

Re: GIMX 3.0

Post by Matlo »

The issue probably lies in the PL2303 windows driver. You should try a USB to UART adapter that is listed in the wiki, like the CP2102.
GIMX creator
User avatar
Matlo
Posts: 5768
Joined: Wed Jul 06, 2011 7:01 am
Location: France
Contact:

Re: GIMX 3.0

Post by Matlo »

You probably forgot to replace the DS4 driver with the libusbK driver.
GIMX creator
gobbledygook
Posts: 3
Joined: Thu Aug 28, 2014 12:17 am
Location: Japan

Re: GIMX 3.0

Post by gobbledygook »

Oh, I had forgotten libusbK driver.
after install libusbK driver, GIMX work fine!

Thank you, Matlo.
User avatar
Matlo
Posts: 5768
Joined: Wed Jul 06, 2011 7:01 am
Location: France
Contact:

Re: GIMX 3.0

Post by Matlo »

You still should make sure your PL2303 adapter is 5V tolerant.
If it's not 5V tolerant it can be damaged in the long term.
GIMX creator
holynoob
Posts: 8
Joined: Sat Jul 19, 2014 12:23 pm

Re: GIMX 3.0

Post by holynoob »

How to flash a HEX to arduino leonardo without destroying a bootloader ? I'd like to know.
Post Reply