Hello everyone,
Im havjng trouble getting my mouse to work at anything higher than 100hz.
Windows 10
Diy gimx adapter
Logitech G203
I played with the buffer and stuff but that doesnt seem to work.
Any suggestions?
Tnx
Mouse polling rate
Re: Mouse polling rate
Hello,
Where did you see that number? If it's on "curses" mode AFAIR remember it's tied to emulated controller refresh rate. Just make sure in your mouse software that DPI is higher and all will be fine.
Regards,
Daniel
Where did you see that number? If it's on "curses" mode AFAIR remember it's tied to emulated controller refresh rate. Just make sure in your mouse software that DPI is higher and all will be fine.
Regards,
Daniel
My hardware: PS3 Slim CFW 4.80 | PS4 Pro 500 Million LE | PS5 | Xbox Series X
Steam: Godlike_RU | PSN: GoDlike_RU | XBL: GoDlike
Steam: Godlike_RU | PSN: GoDlike_RU | XBL: GoDlike
Re: Mouse polling rate
Yes it is in curses at the bottom.
But how do i know it is actually on 250 or 500hz.
On the wiki there is a formula that shows im lagging 100ms with 100hz
But how do i know it is actually on 250 or 500hz.
On the wiki there is a formula that shows im lagging 100ms with 100hz
Re: Mouse polling rate
You can set mouse polling rate in your mouse software, logitech, M8000x drivers etc.
The number you see in curses mode is emulated controller refresh rate. It is not your mouse polling rate.
The number you see in curses mode is emulated controller refresh rate. It is not your mouse polling rate.
My hardware: PS3 Slim CFW 4.80 | PS4 Pro 500 Million LE | PS5 | Xbox Series X
Steam: Godlike_RU | PSN: GoDlike_RU | XBL: GoDlike
Steam: Godlike_RU | PSN: GoDlike_RU | XBL: GoDlike
- kaiba_seto2004
- Posts: 554
- Joined: Sat Jul 15, 2017 9:15 am
Re: Mouse polling rate
You can also raise gimx refresh rate to 250Hz using command line, but it is not necessary.
100Hz is good enough.
100Hz is good enough.
PS4 enthusiast.
Re: Mouse polling rate
100Hz is actually a period of 10ms, which means a worst case latency of 10ms.
GIMX creator