Hi all,
I'm about to purchase an Arduino Pro Micro (http://www.trademe.co.nz/electronics-ph ... 861858.htm)
and a FTDI USB to TTL adapter (http://www.trademe.co.nz/Browse/Listing ... =970576950).
Before I purchase everything I wanted to make sure that everything would work perfectly fine!
Thanks
Wanting to make sure this will work!
Re: Wanting to make sure this will work!
Hi,
It should work. Make sure to set the jumper to 5V.
The Arduino can be easily flashed one time using the Arduino Builder.
After that it's harder to flash because the GIMX firmware reprograms the USB interface, but it's doable: http://gimx.fr/wiki/index.php?title=DIY ... re_loading
It should work. Make sure to set the jumper to 5V.
The Arduino can be easily flashed one time using the Arduino Builder.
After that it's harder to flash because the GIMX firmware reprograms the USB interface, but it's doable: http://gimx.fr/wiki/index.php?title=DIY ... re_loading
GIMX creator