Page 2 of 3
Re: G27->G29 DIY USB using Ubuntu
Posted: Tue Nov 03, 2015 1:04 am
by Cicipso
No I haven't. Shall I?
I'll also test my G27 on PS3 to double check the pedals are working. But last time they were.
Re: G27->G29 DIY USB using Ubuntu
Posted: Tue Nov 03, 2015 6:55 am
by Matlo
No you should not. You can test the pedals with jstest-gtk on Ubuntu.
Re: G27->G29 DIY USB using Ubuntu
Posted: Tue Nov 03, 2015 9:50 pm
by Cicipso
Hey Matlo, thanks for bearing with me so far.
Just tested the G27 with jstest-gtk. All buttons and axis are working, including the 3 pedals.
Any suggestions for next steps?
Shall I try other game than Driveclub?
Re: G27->G29 DIY USB using Ubuntu
Posted: Tue Nov 03, 2015 10:02 pm
by Matlo
Hi,
What is the value range for the pedals? What's the value at rest, and what's the value when fully pressed?
Re: G27->G29 DIY USB using Ubuntu
Posted: Tue Nov 03, 2015 10:23 pm
by Cicipso
Here they are:
Accelerator - axis 2
Rest = 32767
Halfway = 0
Fully pressed = -32767
Break - axis 3
Rest = 32767
Halfway = 0
Fully pressed = -32767
Clutch - axis 1
Rest = 32767
Halfway = 0
Fully pressed = -32767
Re: G27->G29 DIY USB using Ubuntu
Posted: Tue Nov 03, 2015 10:39 pm
by Matlo
Could you uncheck "capture mouse", start GIMX, and check the axis values with jstest-gtk again?
Re: G27->G29 DIY USB using Ubuntu
Posted: Wed Nov 04, 2015 12:09 am
by Cicipso
Did as you say. Same behavior/values as before with the jstest-gtk.
Pedals still not working, tried with PS4 Driveclub again. Captured the log file just in case. Pedals are still not being showed in the log file.
http://pastebin.com/i5Wd3Cyj
Re: G27->G29 DIY USB using Ubuntu
Posted: Wed Nov 04, 2015 7:10 am
by Matlo
Alright, I'll build a test version with more log traces.
Re: G27->G29 DIY USB using Ubuntu
Posted: Wed Nov 04, 2015 7:04 pm
by Cicipso
Ok. Just let me know. Thanks!
Re: G27->G29 DIY USB using Ubuntu
Posted: Wed Nov 04, 2015 8:58 pm
by Matlo
Please install this version:
link.
Then generate a log file and post it.