Game Input MultipleXer

I had used a teensy board and usb converter and it was working great. I bought a new computer and decided to download a newer version of GIMX but the teensy didn't work. So I downloaded the new firmware for the teensy board and uploaded it into the teensy, this did not work. I tried it on the old computer, and it no longer works. I tried putting the old firmware back onto the teensy and it still doesn't work. Is there something special you need to do to wipe the teensy board?

Hi,
Welcome back!
I think you missed an important part of the GIMX 2.xy annoucements:

Read GIMX 1.00 annoucement in case of upgrade from GIMX 0.51 or older.
Read GIMX 1.10 annoucement in case of upgrade from GIMX 1.02 or older.

My guess is that the tx pin of your teensy is not correctly wired to your usb to uart adapter. It wasn't a requirement before version 1.10.

yeah, probably. That's why I went back and tried to load old firmware onto it (the ones I had still from originally making it) but it doesn't work anymore.

I have a teensy 2.0 and I have one in D2 D3 and GND. I don't have any jumper cables to add additional wires. This used to work.

http://neonaito.deviantart.com/art/Teensy-470501020
http://neonaito.deviantart.com/art/Teensy2-470501156

Is the cp2102 recognised by windows?

I actually got it to work with .51, now to figure out how to get it to register my joysticks/start/select/R2/L2 in GIMX again.

What newer version of gimx did you try?

it was 1.something, I will try to install new gimx and new firmware once more.

*UPDATE* Tried to do firmware again, downloaded newest GIMX 2.02. the problem is when I try to start it, it says no controller detected. connector_init failed.
so gonna try again with .51 and figure out if the reason it doesn't work is because I no longer us a joyinmotion and instead ad turn a ps3 into a 360 controller mod.

You tried firmware 1.10 + GIMX 2.02?

Did you install the latest CP2102 driver?