Game Input MultipleXer

Hi,
Im using the USB board and Windows for the PS4.

I load up the launcher after the PS4 is turned on and I see this: http://i.imgur.com/cocYouL.png

(Im not very good at this sort of thing), but there is no controls going being read by the PS4.

One of the problems I have is when I open up the config, this shows up: http://i.imgur.com/pCZfOjK.png

I think that the wiring is good.
I downloaded zadig and changed the driver for the "Wireless Controller" to libusbK.

Here is a screenshot of my devices if that helps: http://i.imgur.com/upxEFcn.png

Any help would be Great!

Thanks.


Edit: I did also install the Tenssy PS4 Drivers

Hi,

Which AVR USB board and which USB to UART adapter are you using?
Where did you bought them?

Did you install the latest CP2102 drivers?

Maybe you have:
- a defective USB cable
- bad wires or bad soldering
- a defective AVR USB board
- a defective CP2102 board
- a voltage mismatch between the boards

USB to UART: http://www.ebay.com/itm/1pc-USB-2-0-to- ... 1046646242

AVR USB board: The Teensy 2.0 :http://www.pjrc.com/store/teensy.html

I have installed the CP driver.

I swapped the cables but I still get the Sony joystick not found.

EscapeThat wrote:I still get the Sony joystick not found.

This is not an error (blue exclamation mark = information message).
The error is not really obvious to see: the "serial_recv" line tells about a serial reception error.

I created a new issue: #295.

I will fix the error handling and upload a test setup so that you can get more details about the error.

Alright thanks!

Here it is: http://gimx.fr/download/b5dc966f74eb6f6 ... x86_64.exe

When I run the launcher I get this: http://i.imgur.com/3AZC95w.png

I uploaded a new setup (same link) with a longer (5s instead of 1s) reception timeout.
Please test it and report if it works or not.

http://i.imgur.com/kAD6a2I.png Odd says no controller detected. Don't think that is a good thing...

I think there's something wrong at the hardware level.
Please take a clear photo of your adapter and post it.