DFP Works for a while then then goes crazy?

[Jord]

Hi all,

Using Teensy 2.0 with Windows 10 to connect Logitech DFP to PS4.

Config wise - all is working ok apparently - wheel works in PS4 with log:

global option -c with value `LogitechDrivingForcePro_G29_W10 - Copy.xml'
controller #1: option -p with value `COM3'
now reading arguments for controller #2
status flag is set
subpos flag is set
force_updates flag is set
native mode is already enabled for HID device \\?\hid#vid_046d&pid_c298#6&1de94cb5&0&0000#{4d1e55b2-f16f-11cf-88cb-001111000030} (PID=c298)
Detected USB adapter: G29 PS4.
using default refresh period: 5.00ms
macros are not available for: joystick PS4 Controller (0)
Warning: can't open macro directory C:\Users\comle\AppData\Roaming//gimx//macros/

Then wheel and controlllr inputs are listed below that.

Only issue I've hit is when I start playing Project Cars. Wheel works fine in menu for PS4 and the game, however when racing starts (using FFB) it lasts about 10 seconds until the wheel just spazzes out and locks all to one side, can't press any buttons, can't use throttle, can't do anything. I have to disconnect PS4 controller to regain control of PS4 and restart it.

Not sure if this is in right area for help but anyone got any ideas?

Thanks,

[Matlo]

Hi,
Could you please generate a log file while the issue happens and post it?

[Jord]

Will do - I wont be able to test until later this week but when I do I'll post below.

[Jord]

Ok managed to get it to happen again and posted log file: http://pastebin.com/CyAfwRMw

It happened after using brake pedal at bottom of log, then wheel and throttle went a bit spastic and locked out

[Matlo]

It's strange, I can't see any error in the log.
It may be due to a faulty contact, or a bad cable.