Game Input MultipleXer

Hey, i got the same problem. I used a Buffer of 2 and a Filter of 1, didnt change the behaviour.
This feels like theres a problem with the refresh rate..

My config looks like this, maybe you can help me out once again..
Feels like its lagging, very stuttery. Dont know if thats what you understand about "jitter".
https://pastebin.com/Ha5MMGp5

Thanks for your help again.
Im using a 2300 dpi mouse (zowie ec2 evo) and tried it with the game Destiny. When im using the 2300dpi mode, its refresh rate is 1000hz. Is this a problem?

I used usbhid mousepoll=4 and rebootet my RPI3.

edit:
You maybe need to fix your Donation Page. After successfully sending the donation, the redirect to the donation page failed with a error message!

Hi,

The calibration page of the wiki may be helpful:
https://gimx.fr/wiki/index.php?title=Mouse_Calibration

Also, there may be performance issues due to the RPi.
You may try upgrading the firmware as suggested here:
https://gimx.fr/wiki/index.php?title=RP ... are_update

Hey Matlo,

i tried the calibration in curse output.
I followed the instructions on the side you listened.

As i understood, dead deadlock settings should be the same for everybody playing the same game?

I set mouse acc and all that stuff according to that page, then i set Buffer 1 and Filter 2 but didn't change anything.

I upgraded the raspberry when i set up the software but instead installed
firmware version 771a503cfc2a1130e2df2a4ddfc45ffa0f592b3f like you wrote in the instruction page.

But still.
Is the problem that im running GUI Mode?
Low load of 0.17 and around 700MB of memory free.

Best regards,
rebornn1337

[youtube]https://youtu.be/H3M8mlPeJts[/youtube]
I made a short video, i wasnt sure if were talking about the same mouse problems. Thanks!
Maybe this also helps other people.

Post your calibrated configuration and I'll have a look.

Matlo wrote: ↑Sat Apr 29, 2017 9:20 am Post your calibrated configuration and I'll have a look.

https://pastebin.com/Ha5MMGp5

Acceleration does not look calibrated.
Try the PS4_Destiny_Cybereu.xml config from the config repository (Help>Get configs in gimx-launcher).

I tried both ways, just downloading the config and also using "auto-bind and convert" but still the stutter is there.

I cant be the only one with these problems, geez.
Thanks for your help so far, really appreciate it.

Always this glimpse of hope

I tried and tried again but still the same result, i've seen that it should work just fine with my mouse.

Anyone any further advice or idea?

Did you try with a PC? This would tell if it's a RPi issue.