Game Input MultipleXer

Hi!

I been trying to get this tested out.

i,ve changed the dongle adress correct.

next step would e to click 'Start' under 'emu'? But i have no idea what the 1 to 6 number tat i can choose means??

And under 'emuclient' i suppose 'grap' should be checked. what about 'output'. i tried 'gui', then a new window appears when i press 'start'. but it dissapears after 2sec. is this supposed to be this way?

I dont get any connection to the ps3, at any point. what am i doing wrong??

greatful for help..

now i get tis error message all of a sudden>
Connection error!
Did you set the dongle address?
If yes, try another dongle!

Did you read the FAQ? There's a few things about connection issues.

the 'connection error' i got was because the sixaxis lost sync with the console.

Now i get the status/calibration to stay open. but without any feedback from mouse och buttons.
I dont see anything about this in the faqs?

I've tried all 'emu'. 0 to 6, but no go. I also choose 'terminal' instead of 'gui'. it only says:

max_axis_value: 255
connected to emu 0

Let 'emu' to 0. You should not change anything that's not mentioned in the tutorial!

If you turn off the ps3 and start emu, does the ps3 turn on?

Hej* :)

sundrik wrote:Now i get the status/calibration to stay open. but without any feedback from mouse och* buttons.
I dont see anything about this in the faqs?

If you're able to turn on the PS3, like Matlo mentions, you've probably just forgotten to replace the mouse/keyboard in the configuration.