Game Input MultipleXer

Hello guys,
I currently live in Bulgaria and i can't find "Teensy" adapter. So that's what i can find: CLICK or will this work: CLICK if not, can you try finding one for me in the following website: CLICK

The "noogroove board" from ebay should work. The firmware to load is the same as the at90usb162.

Thanks for the fast response, but i don't see any pins on it.
PP:CLICK will this one work?

No.

I'm not very experienced with such boards, do you think i'll be able to locate where to put the cables on non-pin board?

D2 and D3 are written on the board.
D2 = Rx
D3 = Tx

The wiring is the same as this one:


You will have to solder wires as there are no pins.

Pressing the two on-board buttons (HWB + RESET) allows to enter the programming mode.

Thank you very much, i would love to support what you're doing somehow!

I just received the development board (NooElec's one). There is one problem and i'm not sure where the problem is. When i connect the board to my laptop and i load Teensy's software for loading a firmware it does not recognize the board. I tried with Atmel's FLIP it does not recognize the board too. Please, help me.
Regards,
Samuil

it wont untill you put the board into programming mode. is there 2 buttons on the board? if so try holding both then letting go of the 1 while holding the other. usb has to be plugged into laptop/pc. not sure which 1 to let go first so try with both.