Page 1 of 3
gimx 1.10 Help
Posted: Fri Oct 25, 2013 9:20 pm
by Johnny Ridden
As for me, there was not a problem with gimix 1.02
However, Gimx-serial cannot start if I revise it
A window opens in spite of a start and is closed immediately
My os is windws8
Re: gimx 1.10 Help
Posted: Sat Oct 26, 2013 5:51 am
by Matlo
Did you update the firmware of your DIY USB adapter?
Re: gimx 1.10 Help
Posted: Sat Oct 26, 2013 6:36 am
by Johnny Ridden
Yes, I did it
I tried it on a EMUPS3 and a Joystick.
Re: gimx 1.10 Help
Posted: Sat Oct 26, 2013 6:57 am
by Matlo
Using the EMUPS3 firmware, is the teensy detected as a "Playstation 3 controller" when plugged to your computer?
Re: gimx 1.10 Help
Posted: Sat Oct 26, 2013 5:17 pm
by Johnny Ridden
Yes
I recognize it
Re: gimx 1.10 Help
Posted: Sat Oct 26, 2013 10:03 pm
by Matlo
Is the tx pin of your teensy correctly wired to the serial adapter?
Re: gimx 1.10 Help
Posted: Sat Oct 26, 2013 11:28 pm
by Johnny Ridden
Yes
I tried TX and TX filler RX and RX
Re: gimx 1.10 Help
Posted: Sun Oct 27, 2013 8:00 am
by Matlo
Type Win+r, and open cmd.
In the command window, type:
Code: Select all
cd "C:\Program Files (x86)\GIMX"
emuclient -p COM12 -c PS3_FarCry3.xml
Replace COM12 with your serial port, and PS3_FarCry3.xml with your config file.
If "No controller detected." is displayed, this means there is something wrong with your wiring or your hardware. In this case, please post a clear picture of your adapter.
Re: gimx 1.10 Help
Posted: Sun Oct 27, 2013 10:02 pm
by Johnny Ridden
Re: gimx 1.10 Help
Posted: Mon Oct 28, 2013 6:50 am
by Matlo
Where did you buy the atmega32u4 board?