failed to read packet header from the GIMX adapter

[Davros]

hi
i build my GIMX adaptor with these :
https://translate.google.com/translate? ... micro.html

https://translate.google.com/translate? ... l2303.html.

i load EMUPS4->atmega32u4.hex with arduino builder 1.0.13 and i get a screen.
then i try to use the Adapter i connect Micro Usb to PS4 and the Usb to the Pc then Start
i get "failed to read packet header from the GIMX adapter"

first

then

[Matlo]

Try using gimx-loader instead: https://backup.gimx.fr/wiki/index.php?t ... g_firmware

Make sure the wiring is correct. If it's not gimx-loader will fail to load the firmware.

[Davros]

Try using gimx-loader instead: https://backup.gimx.fr/wiki/index.php?t ... g_firmware

Make sure the wiring is correct. If it's not gimx-loader will fail to load the firmware.

Connecting to programmer: .avrdude: butterfly_recv(): programmer is not responding

[Matlo]

Post a clear picture showing the wiring.

[Davros]

Post a clear picture showing the wiring.

orange wire = blue wire





adaptor is off on these photo:




some times RED led on "CP2102 USB To TTL Module" is off just some times.

[Davros]

is there any way to flash or reboot arduino pro micro ?
i try short connect with GRD and RST

[Davros]

arduino pro micro is not in arduino builder!!

[Davros]

for first time i load the firmware there was A Com 4 but after that it's gone !!!

[Matlo]

The COM port not being here anymore suggest that firmware was correctly loaded.

However the wiring/soldering looks bad.
Remove the electrical tape and solder the green/yellow/blue wires directly on the pro micro board.
Also I can't be sure from the pictures but I think the tin quality is bad.

[Davros]

i buy a new arduino pro micro first of all

i get a red led in arduino and no led in CP2303 !!!

and one of them i must select for arduino pro micro ?!