occilations

[tr1gg3rtr3v]

Hi Guys, I have my simucube working via gimx and drivehub with a hori controller on a ps5. I am using the g27 pc config as i dont have a ds4 controller. All works including ffb except if i take my hands off the wheel it goes nuts. Is there anything i can do to stop this? I didnt happen when playing wrc 8 (ps4 game) but it did with gt7 (ps5)

[GeekyDeaks]

There was a fairly lengthy 'chat' about it a while ago: viewtopic.php?p=21145#p21145 - I think some of those in the thread were also using the G27 firmware

[tr1gg3rtr3v]

Thanks, just had a read through and you seem quite the legend. I will give it a try and hope it stops them.

[piruloo]

hello I try to connect my augury through drivehub but I have no success, I can't connect, could you help me step by step, I connect drivehud to ps4 with the hori controller then gimx I connect it to the steering wheel input and launch the gimx drivehub seems to detect the g29 but when pressing the assigned ps button it is not detected, I have an arduino leonerdo steering wheel

[jacksondaniel]

It sounds like you're experiencing some interesting feedback issues! Oscillations can definitely be tricky, especially when switching between games like WRC 8 and GT7. Have you tried adjusting the force feedback settings in GT7? Sometimes tweaking those parameters can help stabilize the wheel when you're not holding it. Good luck, and I hope you find a solution!