Doesn't seem to work with the Cronus X. Its basically the same as the Cronus but with a few mod packs. Was just wondering if its just not supported or if its a problem on my end.
When I open gimx, it simply says it doesn't detect anything. I can't select it from the drop down etc. Any help would be appreciated.
Thank you.
CronusX
Re: CronusX
I'll check when I get home from work. Another reason after reading a bit that it might not work- it uses its own firmware I think. Doesn't use GPP firmware I believe its called. I think it can be updated to that.. but then I believe I'll lose the mods. But yeah, when I get home I'll update with a new posted containing that info.
Re: CronusX
How can I tell which one in the device manager is the CronusX device? Probably something simple... but yeah. 
Re: CronusX
Just unplug/replug the CronusX, and you will see what device disappears/reappears.
The Vendor ID is probably unchanged. For the GPP/Cronus it is 0x2508.
The Vendor ID is probably unchanged. For the GPP/Cronus it is 0x2508.
GIMX creator
Re: CronusX
Bump.
It would be nice if someone could provide the VID/PID of the CronusX, so that GIMX can support it!
It would be nice if someone could provide the VID/PID of the CronusX, so that GIMX can support it!
GIMX creator
Re: CronusX
It turns out that the CronusX has the same VID/PID than the Cronus.
The Cronus X should work fine with GIMX.
You have to select GPP as controller type.
The "Device" combo box is grayed out as GIMX doesn't need a USB to serial device to communicate with the GPP/Cronus/Cronus X.
The Cronus X should work fine with GIMX.
You have to select GPP as controller type.
The "Device" combo box is grayed out as GIMX doesn't need a USB to serial device to communicate with the GPP/Cronus/Cronus X.
GIMX creator
Re: CronusX
I only tested with a GPP, but it should work with a Cronus/CronusX as well.
GIMX creator