Here are steps that I made till now:
- Got the CP2104 UART
- Got the Leonardo Pro Micro ATmega32U4 (Arduino Bootloader IDE 1.0.3)
- Connected those two together (RX, TX and GND)
- Programed the ATmega with "Firmwares-5.8/EMUG29PS4/atmega32u4.hex"
- Coneccted ATmega board to PS4, CP2104 board to PC
- Run Gimx-launcher
- my setup:
It doesn't see my DrivingForce GT wheel when I go to Check, I get message "joystick not found: Driving Force GT (0)"
Did try wheel on PC, works without any problem and in Game Controllers it is seen as Driving Force GT USB joypad (for example Assetto Corsa sees it and it works normal)
And when I go to Start I get this:
Code: Select all
global option -l with value `log.txt'
global option -c with value `LogitechDrivingForceGT_G29_W10.xml'
controller #1: option -p with value `COM3'
now reading arguments for controller #2
status flag is set
subpos flag is set
force_updates flag is set
GIMX 5.8 x86_64
Windows 10 (or later) x64
Kernel version: 10.0 (10586)
native mode is already enabled for HID device \\?\hid#vid_046d&pid_c29a#6&2bdb8551&1&0000#{4d1e55b2-f16f-11cf-88cb-001111000030} (PID=c29a)
ReadFile failed: timeout expired.
can't read packet header
No controller detected.
adapter_detect failed