Help! Cannot get GIMX to work with PS4

[ouhks]

Sorry for yet another "Cannot get GIMX to work with PS4" topic...

I just tried to assemble a DIY GIMX adapter to connect my G27 to PS4, but can't get it to work. I have looked at various similar messages on this board, but none of the methods seem to work for me (e.g. swapping the TX/RX cables, renaming the controller name etc). Any help would be much appreciated!

Teensy ++ 2.0 wired up to an USB 2.0 to UART TTL 6PIN Module Serial Converter CP2102 (GND > GND, D2 > TX, D3 > RX).
Loaded the teensy ++ 2.0 with at90usb1286

Below is the log txt:
global option -l with value `log.txt'
global option -c with value `LogitechG27_G29.xml'
controller #1: option -p with value `COM3'
now reading arguments for controller #2
status flag is set
subpos flag is set
force_updates flag is set
GIMX 5.9 x86_64
Windows 10 (or later) x64
Kernel version: 10.0 (10586)
native mode is already enabled for HID device \\?\hid#vid_046d&pid_c29b#6&2d94166e&0&0000#{4d1e55b2-f16f-11cf-88cb-001111000030} (PID=c29b)
ReadFile failed: timeout expired.
can't read packet header
No controller detected.
adapter_detect failed

Thanks!

[Matlo]

Hi,
Please post a clear picture showing the wiring.

[ouhks]

Thanks for helping Matlo

[Matlo]

Did you solder the pins on the Teensy?
It cannot work with unsoldered pins.