Page 1 of 1
Need help on different serial converter wires.
Posted: Fri Jul 15, 2016 5:10 pm
by AHappyWalrus
I am going to be receiving the parts for my DIY USB adapter and I got a different USB 2.0 to UART TTL 6PIN Module Serial Converter CP2102 than the one posted on the usb adapter for dummies page. Just wanted to know which wires I need to use. Thanks!
This is it.
Re: Need help on different serial converter wires.
Posted: Sat Jul 16, 2016 10:49 pm
by Goddard
It should be labeled on the board, or on a diagram that comes with the board. RX to TX and TX to RX and Ground to Ground.
Re: Need help on different serial converter wires.
Posted: Sun Jul 17, 2016 12:55 am
by AHappyWalrus
Ok thanks I will see when it gets here and post if I need anything else.