Axis intensity bug

[kaiba_seto2004]

Hi Matlo,

I encourage a strange bug. When I config axis intensity then I save it, it's good. But when I reopen to config again, its value were changed. I don't know how to fix so I must change value with notepad ++

Here is the screenshot, Dead zone was 32 and steps was 3.


Please give me advice.
Thank you.

[kaiba_seto2004]

The first time I open config with notepad ++, I notice that "Steps" value was changed to "0" instead of "3", "Dead zone" value was changed to "0" instead of "32".

[Matlo]

Hi,

Thanks for reporting. Which GIMX version are you using? You can check it in the Help>About menu.

[kaiba_seto2004]

Hi Matlo,

I'm using Gimx 6.11. Version 64 bit.